| 1. | A method for calculating the elasto - plastic properties of composites
一种计算复合材料弹塑性有效性能的方法 |
| 2. | Standard test method for plastic properties of coal by the constant - torque gieseler plastometer
用恒转矩gieseler塑性计测试塑性的标准试验方法 |
| 3. | For example , the famous modified cambridge model can display the elastic - plastic property of soil , but it can not display the rheological behavior of soil
比如著名的修正剑桥模型能较好的反映土体的弹塑性，但不能考虑流变特性。 |
| 4. | The plastic injection machine is the main equipment of plastic moulding , its technical parameter and performance are closely related with the plastic property and its moulding technology
注塑机是注塑成型的主要设备，注塑机的技术参数和性能与塑料性质和注塑成型工艺有着密切的关系。 |
| 5. | The impression roller , which is the accessory of the electrostatic assist , has achieved same or better performance in the electrical and plastic properties over its competitor ' s one from abroad
与静电吸墨装置配套的东日牌静电压印胶轴在电性能和橡胶性能上都达到了国外同类产品的水平。 |
| 6. | The accidental quenching , occurring in the sintering process , will make the steel back of a powder alloy brake lining brittle and useless . in this paper , an annealing process has been adopted to regain the plastic property of the steel back while the other properties of cg03 brake linings are still remained
粉末合金刹车片在烧结后有时会意外淬火,造成刹车片钢背脆化而报废.采用一种退火工艺,在保持刹车片其它性能的同时,使刹车片钢背恢复塑性 |
| 7. | The result shows that tempered martensite has apparent lath character when temper is between 740 ~ 780 , and the hardness of welded joint is 264 ~ 237hv , which can get better performance of the welded joint the lath character of martensite in welded joint disappears , and the carbide in the tempered sorbite of the base metal will aggregate when temper temperature is above 780 , and the hardness and plastic property will reduce obviously
结果表明，在740 ~ 780之间回火，焊缝硬度为264 ~ 237hv ，回火马氏体板条特征明显，可以获得优良的焊接接头性能；回火温度超过780 ，焊缝板条马氏体特征消失，母材回火索氏体中碳化物产生偏聚，硬度、塑性明显降低。 |
| 8. | It can be seen from the results that the control beam had good plastic property in the static failure experiment after two million fatigue loading circles . all specimens with corroded main bars were failure under the fatigue loads within one million fatigue circles . fatigue lifespan of reinforced concrete beam was sharply shortened after main bars corroded in it and the beam was destroyed bristly without any prediction
试验结果表明,振动测试不能够对锈蚀钢筋混凝土梁的疲劳破坏做出可靠的预测;对比梁在经过200万次疲劳循环加载后的静力试验中仍表现出良好的延性破坏特征;锈蚀梁在100万次疲劳循环内均因主筋疲劳断裂而破坏;主筋锈蚀使得梁的疲劳寿命急剧缩短;梁发生脆性破坏而没有征兆。 |
| 9. | It can obtain the material ’ s dynamic mechanics parameters and also obtain the plot of the material ’ s dynamic stress - strain to analyze the material ’ s dynamic plastic properties . it is concluded that the single crystal silicon ’ s hardness under the dynamic indentation experiment is less than under static indentation experiment and the hardness obtained on the coarse surface is less than on the smooth surface
其次通过对单晶硅材料粗糙表面和光滑表面分别进行动态压痕试验和静态压痕试验,发现单晶硅材料粗糙表面的硬度值小于光滑表面的硬度值,单晶硅材料在动态加载条件下的硬度值小于静态加载条件下的硬度值。 |
